Zehnder ComfoConnect Pro

Use cases

• Monitor supply, extract, outdoor, and exhaust temperatures on a live cloud dashboard for each ventilation installation.
• Create an alert when the filter days remaining drops below a threshold so you can schedule maintenance proactively.
• Track indoor humidity trends over time and correlate them with ventilation fan speed and mode changes.
• Remotely switch ventilation mode between auto and manual or adjust fan speed without an on-site visit.
• Set up notifications for active error codes to detect faults in the Zehnder ComfoAir Q before customers report them.
• Log airflow volume data to verify that the ventilation system delivers the designed air exchange rate.

Installation

1. 1Connect the Zehnder ComfoConnect Pro to the ComfoNet bus of your Zehnder ventilation unit (e.g., ComfoAir Q) and to the local network via LAN or WiFi.
2. 2Run the commissioning wizard on the ComfoConnect Pro, then reboot the gateway via its web interface to ensure Modbus registers return valid data.
3. 3Note the IP address assigned to the ComfoConnect Pro and confirm it is reachable from the ModbusCloud gateway (MCG or MLP series) on the same network.
4. 4Connect and power the ModbusCloud gateway, then register it on the ModbusCloud platform using your installer account.
5. 5Import the Zehnder ComfoConnect Pro template from the ModbusCloud template library and assign it to the gateway, entering the correct IP address and Modbus TCP port.
6. 6Verify that live readings (temperatures, humidity, fan status) appear on the ModbusCloud dashboard and confirm control registers respond as expected.

Things to watch for

01

All Modbus registers return zero or no data after initial setup. What is wrong?

After completing the commissioning wizard, you must reboot the ComfoConnect Pro gateway via its web interface. Without this reboot, Modbus data will not be served correctly.

02

Which firmware version is required on the ComfoConnect Pro?

The template was created and tested with firmware v1.0.4. If you are running an older version, update the gateway firmware through the web interface before importing the template.

03

Can I use Modbus RTU instead of Modbus TCP?

The ComfoConnect Pro supports both Modbus RTU and Modbus TCP. This template is configured for Modbus TCP. If you need RTU, you will need to adjust the connection settings and wiring accordingly.

04

Which Zehnder ventilation units are compatible with this template?

The template supports devices connected via the ComfoConnect Pro, including the ComfoAir Q, ComfoAir Flex, ComfoSwitch C, ComfoSense C, and CO2 Sensor C.

Registers (34)

34 read / 14 write

More TCP templates

Domekt R 400 V

Komfovent

Modbus TCP

Controls Komfovent Domekt recuperator ventilation via Modbus TCP

25 registers118

Fronius - Modbus TCP

Fronius

Modbus TCP

Monitors Fronius Symo and Primo inverters via Modbus TCP

15 registers597

NIBE Nibe S-Series (SG Ready)

NIBE

Modbus TCP

5 registers1

SunSpec Model 709 — DER Trip LF

SunSpec

Modbus TCP

9 registers

Victron Meter AcOut

Victron

Modbus TCP

16 registers

FoxESS Avocado (grid)

FoxESS

Modbus TCP

8 registers